Turnkey system
We take the full scope: design, software, panel, commissioning and handover, against a single point of responsibility.
- One contract, one accountable team
- Fixed deliverables at each stage
- Rolls naturally into a maintenance agreement
From the first I/O schedule to the maintenance visit three years after handover. Take one stage or the whole scope — the same engineers carry it either way.
Everything that has to be decided before anyone picks up a crimping tool. We work from your design specification and produce the drawing set the rest of the project is built from.
You end up with a drawing set another contractor could build from without calling us. That is deliberate — it is your plant, not our lock-in.
Turning the design into working hardware and software. This is where the application logic is written, the panel is built or bought, and the whole thing is proven before it leaves for site.
FAT is not optional. You are welcome to witness it. Faults found on our bench cost a morning; the same faults found on your plant cost a shift.
A perfect drawing set and clean code still meet a plant that is dusty, half-built and running to somebody else’s schedule. Commissioning engineers who wrote the logic themselves solve problems in minutes that would otherwise cost a day of phone calls.
Installation supervision through to the moment your operators take the system over. We plan around your shutdown window rather than asking you to plan around ours.
Shutdown planning. Tell us the window you have and we will sequence the cut-over to fit it, or tell you honestly if it cannot be done safely in that time.
Control systems degrade quietly. Batteries die, backups go stale, spares get borrowed for another line. An annual agreement catches all of it before it becomes a stoppage.
Backups matter most. The single most common reason a plant stays down longer than it should is that nobody can find the current program.
Functional and technical training on any brand of control system, for the people who have to live with it. Delivered at your plant or at our office, built around your own system rather than a demonstration rig.
Any brand. The training is not a sales route into our platforms. If your plant runs a system we did not supply, we will still teach your team to work on it.
You do not have to take the whole scope. Most relationships begin with one stage and grow from there.
We take the full scope: design, software, panel, commissioning and handover, against a single point of responsibility.
You have a panel builder and an electrical contractor. We write the application, run the FAT and support the cut-over.
Scheduled preventive visits plus an agreed response for breakdowns, on systems we built or systems we inherited.
No stage closes on a verbal assurance. Each one produces a document you can check, file and hand to the next contractor.
Every service above is available across the OEM platforms our engineers work in daily.
If your question is not covered, call the Pune office and speak to an engineer rather than a sales desk.
Send your requirementYes, and most clients do. Design-only and software-only engagements are common where you already have a panel builder or an electrical contractor. The deliverables for each stage are written so the next party can pick up cleanly.
We provide functional and technical support for system integration of any brand or make. Legacy takeovers, undocumented panels and controller replacements are routine. Where drawings are missing we can produce an as-built set first.
Either. We can manufacture, or procure to our own design, or work purely on the application software if the panel is already contracted. The design stage produces the same drawing set regardless.
It depends on I/O count and the length of the shutdown window. Tell us the dates when you enquire and we will confirm whether the sequence fits, rather than committing and discovering the problem on site.
Engineering is done from Pune with a branch office at Kalamboli, Navi Mumbai. Commissioning teams travel nationally depending on project scope and duration.
Yes. Training is most effective run shortly after handover while the system is fresh, and it is often bundled into an annual support agreement rather than bought separately.
Send the scope, the platform and the timeline. An engineer will come back to you, not a sales script.
Tell us the sector, the platform and roughly when you need it live.